4
Install The Equipment:
Use 1pcs clamp and 1safety cord(need to purchase).Use clamp fix with light hook which in the
packing box with light, then use screw install to the bottom of lamp. Hang the fixture on the structure
and fasten the screws attached to each clamp. Make sure the light is installed reliable, and confirm
the light which you fixed is strong enough for hanging the light. Base on safety reason, please
according to the above picture using safety wire cross the light to make it strong enough again.
Warning!
1
．
Hook and clamp only use for hanging the light. Do not use clamp as a tool to move fixtures.
2
．
Base on safety reason, please use the safety cord which can afford the weight ten times of lamp
through Insurance hole for auxiliary hanging.
Fitting The Lamp
：
.First removed the iron in the back of the light before fitting/replacing the lamp.
.Good quality bulbs are recommended
.Not charged to install or remove the light bulb.
.Do not touch the light glasss with bare hands
.Fit new lamp and close the back cover by fastening 4 fast-fit screws when finished lamp installation.
.Lamp work will reach a very high temperature, Vapor discharge lamp can not continue to supply this
physical characteristics, therefore, the power completely cool for 10 minutes before on the operation.
Failure to do so will lead to a high-pressure discharge and short circuit burned out the computer's
control panel components.
Notes:
Unplug the light from power before lamp installation or replacement and wait for it to cool.
Power Code Connection:
Connect the power cord as follows:
L (live) =brown
E (earth) =yellow/green
N (neutral) =blue
Use the plug provided to connect the mains power to the projector paying attention to the voltage and
frequency marked on the panel of the projector. It is recommended that each projector be supplied
separately so that they may be individually switched on and off.
★
It is essential that each projector is correctly earthed and the electrical installation conforms
to all relevant standards.
