- 8 -
3. Reception of the Product
3.1 Unloading and checking the product at the time of reception
Although we test and inspect carefully in order to ship an accepted product, please check the
following points upon reception of the delivered product.
•
Is it the exact blower that you ordered?
•
Is the blower free from abnormality due to
transport, such as damage and deformation?
•
Are all the set items enclosed?
•
Are the bolts and nuts tightened without
looseness?
3.2 Movement and transportation
When hoisting the blower for movement or transportation, always use the hoisting holes
indicated as hoisting positions.
Avoid hoisting the blower by using only one point. It is dangerous. The hoisting operation
should be performed by a qualified person.
3.3 Storage before installation
To store the blower before it is installed, cover the overall blower with a weatherproof sheet, etc.,
even if the blower is stored indoors. (Rotate the impeller about 10 times manually once in a
month to prevent corrosion of the bearing etc. (this is also required for the blower adopting
outdoor specifications). When rotating the impeller manually, carefully prevent the hand from
being caught.
4. Installation
4.1 Installation
4.1.1 Selection
of
installation location
Install the blower in a location as shown below.
•
A location at a normal temperature without dew condensation (at a temperature of 10 to
40 °C with a relative humidity of 90% or less)
•
A location where daily inspection and maintenance can easily be performed
•
An indoor location where the blower is not exposed to rainwater
•
A stable location where the blower is free from vibration
•
A location without hazardous chemicals
4.1.2
Base and installation
•
The standard type blower should be installed horizontally. (The specification of vertical
type requires a special order product.)
•
As a rough indication, the appropriate amount of concrete for the foundation is 3 times of
the mass of the blower.
•
To use a mount, install the blower on the horizontal surface with a strong structure.
•
If a gap is found between the blower and the foundation surface, fill the gap by inserting a
liner plate (steel plate to fill a gap), confirm that the blower does not rattle, and then tighten
the foundation bolts.
•
Securely tighten the bolts and nuts.
•
Remove the retaining parts used in transportation, e.g., bolts for retaining
vibration-proofing (flexible) joints, fixing fittings of the vibration-proofing base, etc.
