Show Tec 41280, Руководство пользователя

Страница: 13 / 32

12
Ordercode: 41280
Candela Pix 50
Control Panel
A. OLED Display
B. MODE button
C. UP Button
D. SET Button
E. DOWN Button
Fig. 06
DMX Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address the next time.)
DMX Addressing
The control panel on the backside of the device allows you to assign the DMX fixture address, which is
the first channel from which the Candela Pix will respond to the controller. Please note when you use the
controller, the unit has up to 28 channels. When using multiple Candela Pixs, make sure you set the DMX
addresses right. Therefore, the DMX address of the first Candela Pix should be 1(001); the DMX address of
the second Candela Pix should be 1+28=29 (029); the DMX address of the third Candela Pix should be
29+28=57 (057), etc. Please, be sure that you do not have any overlapping channels in order to control
each Candela Pix correctly. If two or more Candela Pixs are addressed similarly, they will work similarly.
Controlling:
After having addressed all Candela Pixs, you may now start operating these via your lighting controller.
Note: After switching on, the Candela Pix will automatically detect whether DMX 512 data is received or
not. If there is no data received at the DMX-input, the text “DMX In“ on the control panel will not appear.
If not, the problem may be:
●
The XLR cable from the controller is not connected with the input of the Candela Pix.
● The controller is switched off or defective, the cable or connector is defective, or the signal wires are
swapped in the input connector.
Note: It is necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Display Off after 25 seconds
When no button is pressed for 30 seconds, the display will turn off. To light up the display, you have to
press the MODE and SET button. When the timer on the display reaches zero, release the buttons and the
display will light up.