INSTALLATION INSTRUCTIONS:
Cow Model:
1.
Mount control box: Securely attach control box on one side of
arena. It should be mounted so pulleys on bottom of box are
approximately 45 inches from the ground.
2.
Mount return pulley: Mount off-side return pulley on opposite side
of arena in horizontal position. It should also be mounted
approximately 45 inches from the ground. See attached
instructions for machines using a cable tensioner.
3.
Install kevlar cable: Have an assistant hold cable in center of
arena. Take end of cable attached to slide tube around off-side
pulley, across arena, around both pulleys on bottom of control box,
and back to center.
Be sure the straight slide tube slides freely
on the back part of the loop.
Tie opposite end of cable to slide
tube and tighten removing as much slack as possible. Tie s knot
and cut off extra cable. Keep in mind that the objective is to form a
loop with the cable. The slide tube with two snaps supports the
cow’s head, and the slide tube with one snap (slides freely on back
part of loop) supports the cow’s shoulder.
4.
Install "TECH" line: The tech line is static and supports the cow’s
hip. A slide tube is pre-installed on this line. Tie one end of tech
line to fence as close to control box as possible. There should be
no more than 2 – 3 inches between the back part of the loop and
the tech line. Tie to fence on opposite side of arena and tighten.
Installing tech line close to shoulder line causes the cow to travel
flat, stop flat, and turn around smoothly.
5.
Apply power: Plug Pro Cutter into grounded 120VAC, 3-prong
outlet. Always unplug unit when not in use.
*EURO MODELS:
240VAC/50Hz
6.
Attach cow: Following the included drawing, attach cow to slide
tubes on kevlar cable and tech line.
7.
Power on Remote: A power button is located on the right side of
the remote control pouch. Press to turn ON.
Note:
The power indicator light does
NOT
illuminate when power
is ON. It only illuminates when you press the directional switches
on the remote control or the Stepper switches.
(
Refer to Performance Package instructions on page 9
.)
