13
Flange Components Installation
STEP 1:
Add a 1/4" continuous bead of clear silicone
to the inside of each Flange. Read and
follow the manufacturers instructions for
silicone application. See FIGURE 2.24
STEP 2:
Carefully rotate the flanges to ensure the
attachment holes are parallel to the cage
floor. See FIGURE 2.25
STEP 3:
Insert the Female Flange Component
through the hole/Spacer. The arrow and
notch on the Flange should point upward.
See FIGURE 2.26
STEP 4:
Insert the Male Flange Component inside the Female Flange Component. The
arrow, SHOR-LINE logo and notch on the Flange should be in the upward
position. See FIGURE 2.27
FIGURE 2.25 - Connection
EQUAL
DIST
ANCE
EQUAL
DIST
ANCE
Carefully rotate the flanges to
ensure the attachment holes
are parallel to the cage floor.
FIGURE 2.26 - Female Flange
FIGURE 2.27 - Male Flange
STEP 5:
Use two #8-16X1 PAN HD phillips screws to secure the two flanges together. The
screws thread into the plastic flange. See FIGURE 2.28
STEP 6:
Wipe clean any Silicone that has oozed out between the Flange and Cage wall.
See FIGURE 2.29
Do NOT over-tighten the screws, damage to the components could occur.
FIGURE 2.28 - Secure Flanges
FIGURE 2.29 - Clean Portal
FIGURE 2.24 - Silicone Application
SECTION TWO
