HAND DRIVE CONTROLS
1 :rear brake lever
2 :engine stop switch
3 :front brake lever
4 : throttle handle
BEFORE YOU BEGIN
Remove contents from box. Inspect the contents of the box for scratches in the paint, dents or
kinked cables that may occur during shipping. Because the product was 85 percent assembled
and packed at the factory, there should not be any problems, even if the box has a few scars
or dents.
Estimated Assembly and Set-Up Time
We recommend assembly by an adult with experience in motorbike or bicycle mechanics.
Allow up to 30-40 minutes for assembly.
Required Tools
Some tools may be supplied; however, we recommend the use of mechanic’s grade tools. Use
the supplied tools only as a last resort.
The list of tool required is as follows
·
Open end wrench 10mm / 13mm/ 17mm / 22mm
·
Allen wrench 5mm / 6mm/ 8mm
Assembly illustration and instruction
ASSEMBLY HANDLEBAR
WARNING
: Failure to properly adjust and tighten the bolts that affix the handlebar can cause
you lose control and crash.
1. place the handlebar (A) in the bottom
clamp, then cover the upper clamp (B) on
the handlebar and install the 4pcs bolt (C)
2. Place the handlebar in the upright and
vertical position, then tighten all the bolts
securely with 10mm socket spanner.
A
:
handlebar
B
:
upper clamp
C
:
bolt M8X20 4pcs