Shop-Vac SH14-C350, Руководство пользователя

Страница: 9 / 36

46. Your vacuum can be used as
a powerful blower. To use your
unit as a blower, clear hose of any
obstructions. Insert machine hose
end into blower port on rear of
unit.
FIGURE 25
. Twist slightly
to tighten the connection. Caution
should be used when using as a blower due to the
powerful force of air when using certain attachments.
PAGE 8
BLOWER
FEATURE
FIGURE 25
WARNING!
FIGURE 24
FOAM SLEEVE INSTALLATION AND CLEANING:
41. With tank cover in an upside
down position, slide foam sleeve
down over lid cage pulling until
foam sleeve completely covers lid
cage. FIGURE 24.
42. To clean the foam sleeve, disconnect the plug from
the wall outlet. Remove the tank cover and place the
cover in an upside-down position. Remove foam sleeve
by sliding it up and off the lid cage.
43. Shake excess debris off of the foam sleeve with a
rapid up and down movement.
44. Hold foam sleeve under running water for a minute
or two, rinsing from the inside of the filer. A water wash
is not always required, depending on the condition of
the foam sleeve.
45. Check the filter for tears. If any are found, replace
with a new filter.
ALWAYS WEAR EYE PROTECTION TO PREVENT
ROCKS OR DEBRIS FROM BEING BLOWN OR
RICOCHETING INTO THE EYES OR FACE WHICH
CAN RESULT IN SERIOUS INJURY.
EMPTYING LIQUID
WASTE FROM THE
TANK
47. Your wet/dry vacuum can be emptied of liquid waste
by removing the tank cover. To empty, turn unit off and
remove plug from the wall receptacle. Remove the tank
cover and deposit the liquid waste contents in a suitable
drain. After the tank is empty, return the tank cover to
its original position. To continue use, plug the cord into
the wall receptacle and turn the unit on. Use side carry
handles for lifting vac when draining tank into drains
that are located above floor level.
38. Misting in the exhaust air or dripping of liquid
around the tank cover may occur if the filter becomes
saturated during wet pick up. If this occurs, remove the
filter and allow to dry, or replace with another dry filter.
39. Turn the unit off immediately upon completing a
wet pick up job or when tank is full and ready to be
emptied. When the tank is full, suction will drastically
reduce. Refer to “automatic suction shut off” in this
manual. Raise the hose to drain any excess liquid into
the tank. Follow the “emptying liquid waste” section in
this manual.
40. Before storing the vacuum cleaner or using for dry
pick up, clean and dry the interior of the tank and the
underside of the tank cover. Clean and allow the filters
to dry completely.
NOTE: WET PICK UP ACCESSORIES SHOULD BE
WASHED PERIODICALLY; ESPECIALLY AFTER PICKING
UP WET, STICKY KITCHEN ACCIDENTS. THIS CAN BE
ACCOMPLISHED WITH A WARM SOLUTION OF SOAP
AND WATER.
AUTOMATIC SUCTION
SHUT OFF
48. The vacuum is equipped with an automatic suction
shut-off that operates when picking up liquids. As the
level of the liquid rises in the tank, an internal float rises
until it seats itself against a seal at the intake of the
motor, shutting off suction. When this happens, the
motor will develop a higher than normal pitch noise and
the suction is drastically reduced. If this occurs, turn
unit off immediately. Failure to turn unit off after float
rises and shuts off suction will result in extensive
damage to the motor. To continue use, empty the liquid
waste from the tank as outlined in the previous
section.