Shop-Vac SH14-C350, Руководство пользователя

Страница: 7 / 36

FILTER
INSTALLATION
AND CLEANING
DRY PICK UP
OPERATION
16. Attach one of the cleaning accessories (depending
on your cleaning requirements) on the extension wands.
Twist slightly to tighten the connection. FIGURE 11.
PAGE 6
ALWAYS DISCONNECT THE
PLUG FROM THE WALL OUTLET
BEFORE REMOVING THE TANK
COVER.
WARNING!
Questions?
Visit www.shopvac.com 24 hours a day.
NOTE: Never use the vacuum for dry pick up without a
dry use filter installed on the lid cage. Using the vacuum
without a filter will cause dust to discharge from blower
port and cause damage to motor.
INSTALLING AND CLEANING THE CARTRIDGE
FILTER:
FIGURE 12
17. Plug the cord into the wall outlet. Your cleaner is
ready for use. I = ON, O = OFF.
NOTE:
Many more useful tools are available at your
local dealer or Shop-Vac® website.
NOTE: If foam sleeve (not standard with all models)
is installed on lid cage, remove before installing the
cartridge filter.
18. The cartridge filter can be used for dry pick up and
small quantities of wet pick up. Installation is the same
for both. When picking up large quantities of water we
recommend using a foam sleeve (not standard with
all models) instead of the cartridge filter. When pick-
ing up fine dust or powders a high efficiency filter bag
(not standard with all models) must be used with
the cartridge filter.
FIGURE 13
FIGURE 14
FIGURE 15
20. Place filter retainer into the
top of the cartidge filter.
FIGURE 13.
21. Hold the tank cover with
one hand, turn the handle on
the filter retainer clockwise to
tighten, locking the filter into
place.
FIGURE 14.
22. To remove the filter for
cleaning, again hold the
tank cover and turn the filter
retainer counter-clockwise to
loosen and remove.
FIGURE 15.
NOTE:
If cartridge filter has been used for wet pick
up, it must be cleaned and dried before using it for dry
pick up.
19. With the tank cover in an
upside down position, slide
the cartridge filter down over
the lid cage, pushing until the
filter seals against the cover.
FIGURE 12.
FIGURE 16
FIGURE 17
FIGURE 18
23. Slide the cartridge filter off
the lid cage.
FIGURE 16.
24. To clean cartridge filter
shake or brush off excess dirt.
FIGURE 17.
25. Or rinse (from the inside of
the filter) with water.
FIGURE 18 . Dry completely
(approximately 24 hours).