Shop-Vac SEP SERIES, Руководство пользователя

Страница: 9 / 40

PAGE 8
TO REDUCE THE RISK OF ELECTRICAL SHOCK, DO
NOT DIRECT DISCHARGE STREAM AT UNIT!
THE CARTRIDGE FILTER IS NOT COMPATIBLE WHEN
UTILIZING THE PUMP PICK UP ASSEMBLY.
WARNING!
WARNING!
WET PICK UP
OPERATION
PUMP
OPERATION
FIGURE 24
FIGURE 25
FIGURE 26
35. Your vacuum can be used for wet pick up. Remove
ALL dirt and debris found in the tank. Remove all
dry use only filters, including the filter bag, from the
vacuum.
36. A clean cartridge filter may be used to pick up small
quantities of liquid. To use the cartridge filter; follow
the cleaning and installation instructions under dry
pick up.
37. For vacuuming large quantities of liquid use a foam
sleeve. To use the foam sleeve; follow the installation
instructions in this section.
38. Misting in the exhaust air or dripping of liquid
around the tank cover may occur if the filter
becomes saturated during wet pick up. If this
occurs, remove the filter and allow to dry, or replace
with another dry filter.
39. Turn the unit off immediately upon completing
a wet pick up job or when tank is full and ready
to be emptied. When the tank is full, suction will
drastically reduce. Refer to “automatic suction shut
off” in this manual. Raise the hose to drain any
excess liquid into the tank. Refer to the Emptying
Liquid Waste section in this manual.
40. Before storing the vacuum cleaner or using for dry
pick up, clean and dry the interior of the tank and
the underside of the tank cover. Clean and allow the
filters to dry completely.
NOTE: WET PICK UP ACCESSORIES SHOULD BE
WASHED PERIODICALLY; ESPECIALLY AFTER PICKING
UP WET, STICKY KITCHEN ACCIDENTS. THIS CAN BE
ACCOMPLISHED WITH A WARM SOLUTION OF SOAP
AND WATER.
FOAM SLEEVE INSTALLATION
AND CLEANING:
41. With tank cover in an upside
down position, slide foam sleeve
down over lid cage pulling until
foam sleeve completely covers lid cage. FIGURE 24.
42. To clean the foam sleeve, disconnect the plug from
the wall outlet. Remove the tank cover and place
the cover in an upside-down position. Remove foam
sleeve by sliding it up and off the lid cage.
43. Shake excess debris off of the foam sleeve with a
rapid up and down movement.
44. Hold foam sleeve under running water for a minute
or two, rinsing from the inside of the filter. A water
wash is not always required, depending on the
condition of the foam sleeve.
45. Check the filter for tears. If any are found, replace
with a new filter.
NOTE: To use the pump operation feature refer to the
Pump Operation section.
NOTE:
Not for use as a sump pump. Do not leave unit
unattended while in use.
Set-up:
46. The pump feature allows you to vacuum large
amounts of liquid without having to manually empty
heavy tanks of liquid. Always disconnect the plug
from the wall receptacle before removing the tank
cover. Remove the tank cover.
47. Remove any filters, other than foam sleeve,
installed on the vacuum. If not already done, install
foam sleeve. Refer to the filter installation and
maintenance section for installation instructions.
48. Remove ALL dirt and debris found in tank.
49. Insert tube into pick up cage
and push until tube comes to
a stop. FIGURE 25 .
50. Take pick up assembly from
step 49 and insert tube into
hole in bottom of lid cage
and push until assembly
comes to a stop FIGURE
26
.
NOTE: Do not attempt to
pump without pick up cage
in place or screen on pick up
cage. Failure to do this could
result in damage to pump.