Shop-Vac SEP SERIES, Руководство пользователя

Страница: 6 / 40

Pull lid latches in an outward motion and remove tank
cover. Remove any accessories and literature that may
have been packed in the vacuum tank.
UNPACKING
ASSEMBLY
CASTER SYSTEM
ASSEMBLY
PAGE 5
You will find four caster feet
FIGURE 1
, four casters
FIGURE 2
, four screws, and
four washers with your wet/dry
vacuum. Assemble as follows:
1. With cord disconnected from receptacle and tank
cover removed, turn tank upside down so that the
bottom is facing up.
A
A
A
A
2
. With tank drain facing you,
take caster feet marked with
letter A and place in slots on
left front and right rear of
tank also marked with the
letter A .
FIGURE 3
.
B
3
. Secure with screws
provided.
FIGURE 4
.
B
B
B
B
A
A
4. Take caster feet marked with
the letter B and place on
right front and left rear of
tank also marked with the
letter B . FIGURE 5 .
5. Secure with screws provided.
FIGURE 6
.
6. Take flat washer and place
over stem of caster. Insert
casters into feet by placing
stem of caster into holes
provided. Apply pressure and
twisting motion until casters
snap into place.
FIGURE 7
.
7. Return tank to upright position.
FIGURE 1
FIGURE 2
FIGURE 6
FIGURE 7
FIGURE 3
FIGURE 4
FIGURE 5
TOOL HOLDER
ASSEMBLY
FIGURE 8
FIGURE 9
FIGURE 10
8. With rear of unit facing you,
take tool holder and position
it with tabs facing rear of
unit. FIGURE 8 .
9. Place “J” shaped tabs into
the slots on cord wraps.
FIGURE 9 . Press down
until tabs snap into place.
10. Press down on center of
tool holder until tab latches
on bottom of lid. FIGURE
10 .
11. Before replacing tank cover, ensure you have the
proper filters installed for your cleaning operation.
A. For dry pick up refer to Dry Pick Up Operation
B. For wet pick up refer to Wet Pick Up Operation
C. When using the pump operation refer to
Pump Operation
GENERAL SET UP