To pick up dust and dry material, you must install foam sleeve and reusable dry filter or
disposable filter bag to ensure proper filtration. If the vacuum has been used to pick up
liquids, the foam sleeve must be cleaned and dried before installing for dry pick up. With
tank cover in an upside down position, slide foam sleeve down over lid cage pulling until
foam sleeve completely covers lid cage
(Figure 1, 2)
. Center the reusable dry filter (not
standard with all models) on lid cage
(Figure 3)
, slide mounting ring down over filter until
ring is positioned against the ribs of the lid cage
(Figure 4)
. The reusable dry filter
should always be in position over the foam sleeve for dry pick up. To remove the filter for
cleaning, remove mounting ring and filter from lid cage
(Figure 5)
. To clean the reusable
dry filter, shake off excess dirt and dust or (depending on the condition of the filter) rinse
with water. Allow the filter to dry completely and re-install.
NOTE: ENSURE THAT THE MOUNTING RING IS COMPLETELY SECURE AND IN POSITION BY PRESSING DOWN FIRMLY AROUND THE RING IN
SEVERAL PLACES. BE SURE THE REUSABLE DRY DISC FILTER COMPLETELY COVERS THE FOAM SLEEVE. CHECK TO ENSURE THAT ALL EDGES OF
THE REUSABLE DRY FILTER ARE SECURE UNDER THE MOUNTING RING.
GROUNDING INSTRUCTIONS
EXTENSION CORDS
NOTE:
STATIC SHOCKS ARE COMMON IN DRY AREAS OR WHEN THE RELATIVE HUMIDITY OF THE AIR IS LOW. THIS IS ONLY TEMPORARY AND
DOES NOT AFFECT THE USE OF THE APPLIANCE. TO REDUCE THE FREQUENCY OF STATIC SHOCKS IN YOUR HOME, THE BEST REMEDY
IS TO ADD MOISTURE TO THE AIR WITH A CONSOLE OR INSTALLED HUMIDIFIER.
Use only a cord extension set that complies with AS3199. Conductor size must be 1.0mm
2
for length up to 25 metres and 1.5mm
2
for length
from 25 - 32 metres.
UNPACKING AND SET-UP
Remove tank cover and any accessories which may have been
shipped in the tank.
Before replacing tank cover, please refer to DRY PICK UP or WET
PICK UP OPERATION in this manual to ensure you have the proper
filters installed for your cleaning operation.
Replace tank cover.
1.
2.
3.
4.
Attach the extension wands to the accessory end of the hose.
Twist slightly to tighten the connection.
Attach one of the cleaning accessories (depending on your
cleaning requirements) to the extension wand. Twist slightly to
tighten the connection
Plug the cord into the wall outlet. Your cleaner is ready for use.
I = ON O = OFF
5.
6.
7.
WARNING -
ALWAYS DISCONNECT THE PLUG FROM THE WALL OUTLET BEFORE REMOVING THE
TANK COVER.
1
2
3
4
5
2a
INSTALLING THE FOAM SLEEVE AND DRY FILTER DISC
•
NOT STANDARD ON ALL MODELS
DRY PICK UP OPERATION
ELECTRIC SHOCK. CHECK WITH A
QUALIFIED ELECTRICIAN OR
SERVICE PERSON IF YOU ARE IN
DOUBT AS TO WHETHER THE
OUTLET IS PROPERLY GROUNDED.
DO NOT MODIFY THE PLUG
PROVIDED WITH THE APPLIANCE –
IF IT WILL NOT FIT THE OUTLET,
HAVE A PROPER OUTLET
INSTALLED BY A QUALIFIED ELECTRICIAN
.
This appliance must be grounded. If it should malfunction or
breakdown, grounding provides a path of least resistance for electric
current to reduce the risk of electric shock. This appliance is
equipped with a cord having an equipment-grounding conductor and
grounding plug. The plug must be inserted into an appropriate outlet
that is properly installed and grounded in accordance with all local
codes and ordinances. This appliance is for use on a nominal
240-volt circuit, and has a grounded plug that looks like the plug
illustrated in
sketch A
.
WARNING
–
IMPROPER CONNECTION OF THE
EQUIPMENT-GROUNDING CONDUCTOR CAN RESULT IN A RISK OF
NOTE:
If power cord needs to be replaced, use only a Shop-Vac
Service Agent.
Grounded
Outlet
Grounding
pin
(A)
Slip cleaner end of flexible hose into the intake port.
cover accessories. Simply return the complete unit, (transportation prepaid), to the Authorized Shop-Vac Service Centre nearest you (a complete
list of Authorized Shop-Vac Service centres is included with each vacuum cleaner). Shop-Vac assumes no responsibility for damage or faulty
performance caused by misuse or careless handling, or where repairs have been made or attempted by others. Proof of purchase date is
required. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
DOUBLE INSULATION
Do not operate if cord, plug or appliance is damaged. In your double insulated appliance, two systems of insulation are provided instead of
grounding. No grounding means is provided nor should a means for grounding be added to the appliance.
NOTE:
If power cord needs to be replaced, use only a Shop-Vac Service Agent.
