THIS EQUIPMENT INCORPORATES PARTS SUCH AS SWITCHES, MOTORS OR THE LIKE THAT TEND
TO PRODUCE ARCS OR SPARKS THAT CAN CAUSE AN EXPLOSION. DO NOT PICK UP FLAMMABLE,
COMBUSTIBLE, OR HOT MATERIALS. DO NOT USE AROUND EXPLOSIVE LIQUIDS OR VAPORS, AS
ELECTRICAL DEVICES PRODUCE ARCS OR SPARKS WHICH CAN CAUSE A FIRE OR EXPLOSION - DO NOT
USE AT FILLING STATIONS OR ANYWHERE GASOLINE IS STORED OR DISPENSED.
OPERATION
WARNING
– ALWAYS TURN UNIT OFF AND DISCONNECT FROM CHARGER OR VEHICLE OUTLET BEFORE REMOVING THE TANK COVER.
NEVER OPERATE UNATTENDED!
The vacuum may be operated using the internal battery or by plugging it into a vehicle outlet. With the rear of the vacuum facing you, locate the selector switch to the left of the charging port
(Figure 7).
BATTERY OPERATION:
To use the internal battery, move the selector switch to the left position. If battery power discharges before the cleaning job is finished, follow the Charging Battery
instructions in this manual to recharge the battery.
NOTE:
The battery should
NOT
be run completely down.
VEHICLE OUTLET:
To use a vehicle outlet, move the selector switch to the right position. Insert plug on vehicle power cord into charging port on rear of vacuum
(Figure 8).
Plug vehicle power
cord into vehicle outlet.
NOTE:
The vehicle outlet may not have power while the vehicle is turned off. Refer to the operation manual that came with the vehicle.
7
8
CAUTION
–
RISK OF FIRE. DO NOT REPLACE ANY VEHICLE FUSE WITH A RATING HIGHER THAN RECOMMENDED BY THE VEHICLE
MANUFACTURER. THIS PRODUCT IS RATED TO DRAW 11 AMPERES FROM A 12 V VEHICLE OUTLET. ENSURE THAT THE ELECTRICAL SYSTEM IN
YOUR VEHICLE CAN SUPPLY THIS PRODUCT WITHOUT CAUSING THE VEHICLE FUSING TO OPEN. THIS CAN BE DETERMINED BY MAKING SURE
THE FUSE IN THE VEHICLE WHICH PROTECTS THE OUTLET IS RATED HIGHER THAN 12 AMPERES. INFORMATION ON THE VEHICLE FUSE RATINGS
ARE TYPICALLY FOUND IN THE VEHICLE OPERATOR’S MANUAL. IF A VEHICLE FUSE OPENS REPEATEDLY, DO NOT KEEP ON REPLACING IT. THE
CAUSE OF THE OVERLOAD MUST BE FOUND. ON NO ACCOUNT SHOULD FUSES BE PATCHED UP WITH TIN FOIL OR WIRE AS THIS MAY CAUSE
SERIOUS DAMAGE ELSEWHERE IN THE ELECTRICAL CIRCUIT OR CAUSE FIRE.
DRY PICK UP OPERATION
INSTALLING FOAM SLEEVE AND COLLECTION BAG
1. Install foam sleeve and collection bag to pick up dust and dry material only. If the foam sleeve has been used to pick up liquids, the foam sleeve must be cleaned and dried before installing
for dry pick up.
2. With tank cover in an upside down position, slide foam sleeve down over filter cage pulling until foam sleeve completely covers filter cage
(Figure 9).
3. To install collection bag, remove hose from inlet.
4. Slide collar of filter bag into retainer guides
(Figure 10).
5. When secured in place, expand bag and position around the inside of the tank. The collection bag should always be in position when using the foam sleeve for dry pick up.
10
9
CAUTION
– KEEP FILTERS CLEAN
EFFICIENCY OF THE VACUUM IS LARGELY DEPENDENT ON THE FILTER. A CLOGGED FILTER CAN CAUSE OVERHEATING AND POSSIBLY DAMAGE THE CLEANER. CHECK THE FILTER PERIODICALLY
AND REPLACE AS REQUIRED. DO NOT MACHINE WASH OR DRY. DO NOT USE THE VACUUM OR FILTERS FOR COLLECTING HAZARDOUS OR OTHER HEALTH ENDANGERING MATERIALS.
