Shop-Vac 87556-50, Руководство пользователя

Страница: 8 / 36

PAGE 7
45. To clean the foam sleeve, disconnect the plug from
the wall outlet. Remove the tank cover and place the
WARNING!
37. When secured in place, expand the filter bag and
position around the inside of the tank. Replace tank
cover.
NOTE: When removing filter bag from tank, remove the
inlet deflector from the filter bag collar. Reinstall inlet
deflector into deflector guide. Inlet deflector must be in
place for any type of cleaning.
FOR FINE DUST POWDERS
When vacuuming fine dust, or powders of
any kind (plaster, drywall dust, cold ashes,
concrete dust, etc.) a high efficiency
drywall filter bag must be used. When vacuuming
normal household dust and debris, standard household
disposable filter bags may be used.
35. Slide the inlet deflector
with the filter bag attached
into the deflector guide.
FIGURE 26
.
36. Reinsert hose into inlet
and tighten the locking-nut.
FIGURE 27 .
FIGURE 26
FIGURE 27
WET PICK UP
OPERATION
38. Your vacuum can be used for wet pick up. Remove
ALL dirt and debris found in the tank. Remove all
dry use only filters, including the filter bag, from the
vacuum.
39. A clean cartridge filter may be used to pick up small
quantities of liquid. To use the cartridge filter; follow the
cleaning and installation instructions under dry pick up.
40. For vacuuming large quantities of liquid use a foam
sleeve (not standard with all models) . A foam sleeve
may be purchased at your local Shop-Vac
®
distributor,
on the Shop-Vac
®
website, or by contacting Shop-Vac
®
customer service. To use the foam sleeve; follow the
installation instructions in this section.
41. Misting in the exhaust air or dripping of liquid
around the tank cover may occur if the filter becomes
saturated during wet pick up. If this occurs, remove the
filter and allow to dry, or replace with another dry filter.
42. Turn the unit off immediately upon completing a
wet pick up job or when tank is full and ready to be
emptied. When the tank is full, suction will drastically
reduce. Refer to “automatic suction shut off” in this
manual. Raise the hose to drain any excess liquid into
the tank. Follow the “emptying liquid waste” section in
this manual.
43. Before storing the vacuum cleaner or using for dry
pick up, clean and dry the interior of the tank and the
underside of the tank cover. Clean and allow the filters
to dry completely.
NOTE: WET PICK UP ACCESSORIES SHOULD BE
WASHED PERIODICALLY; ESPECIALLY AFTER PICKING
UP WET, STICKY KITCHEN ACCIDENTS. THIS CAN BE
ACCOMPLISHED WITH A WARM SOLUTION OF SOAP
AND WATER.
FOAM SLEEVE INSTALLATION AND CLEANING:
FIGURE 28
44. With tank cover in an
upside down position, slide
foam sleeve down over lid
cage pulling until foam
sleeve completely covers lid
cage.
FIGURE 28.
34. Position the inlet
deflector with the opening
facing the left or the right
side of the filter bag. Slide
the filter bag collar over the
inlet deflector, matching the
notches of the bag collar to
the tabs on the inlet
deflector. Bag will only fit
properly one way. FIGURE
25 .
FIGURE 25
33. Remove the inlet
deflector from the deflector
guide. NOTE: Hose must
be removed before the inlet
deflector can be taken out.
FIGURE 24 .
FIGURE 24