PAGE 5
FIGURE 2
FIGURE 5
FIGURE 6
FIGURE 7
2. With cord disconnected from receptacle and tank
cover removed, turn tank upside down so that bottom is
facing up. Remove any webbing that attaches the caster
feet to each other.
6. Make sure caster feet are fully
inserted into tank bottom and
secure with screws provided.
FIGURE 6
.
7. Insert casters into feet by
placing stem of caster into holes
provided. Apply pressure and
twisting motion until casters
snap into place
FIGURE 7
.
Return tank to upright position.
Assemble as follows:
10. With rear of unit facing you,
take tool holder and position it
with tabs facing rear of unit.
FIGURE 10
.
11. Place “J” shaped tabs into the
slots on cord wraps
FIGURE 11
. Press down until
tabs snap into place.
12. Press down on center of tool
holder until tab latches on bottom
of lid.
FIGURE 12.
TOOL HOLDER
ASSEMBLY
FIGURE 10
FIGURE 11
FIGURE 12
3. With tank inlet facing you,
take caster feet marked with
the letter
A,
FIGURE 3
, and
place in the slots on left front
and right rear of tank also
marked with the letter
A
.
A
A
A
A
FIGURE 3
B
FIGURE 4
4. Make sure caster feet are fully
inserted into tank bottom and
secure with screws provided.
FIGURE 4
.
B
B
B
B
A
A
5. Take caster feet marked
with the letter
B
and place on
right front and left rear of tank
also marked with the letter
B
.
FIGURE 5
.
8. With tank inlet facing
you, attach hose holder A
to caster foot A, and hose
holder B to caster foot B.
FIGURE 8.
FIGURE 8
9. Apply pressure to front
of hose holder to snap into
place.
FIGURE 9.
FIGURE 9
