Shop fox W1831, Руководство пользователя

Страница: 19 / 36

-17-
Model W1831 (For Machines Mfd. Since 6/15)
O
PE
R
ATIO
NS
Sanding.Drum/Sleeve.
Installation
To ensure the workpiece is supported during sanding
operations, use the table insert that matches the
corresponding drum and sleeve (see Figure 11 ). It is
important to keep the gap between the table insert and
drum as small as possible to reduce the risk of a pinch
hazard.
To.install.or.replace.a.sanding.drum/sleeve,.do.these.
steps :
1. DISCONNECT SANDER FROM POWER.
2. While holding the sanding drum and sleeve, use the
arbor wrench to loosen and remove spindle hex nut.
3. Remove the spindle washer, sanding sleeve, sanding
drum, table insert and base washer (see Figure 12 ).
4. Clean the table opening for the table insert and any
other spindle areas as necessary. There should be no
sawdust on the ledge of the table opening where the
table insert is placed or the table insert will not sit
flush with the table.
5. Use the table in Figure 11.
to select the required size
of components for the sanding drum/sleeve size you
have chosen.
6. Insert the base washer, then install the desired
sanding drum on the spindle shaft, followed by the
corresponding sanding sleeve on the drum, as shown
in Figure 12 .
7. Secure the sanding drum with appropriate spindle
washer and the spindle hex nut. Tighten until the
rubber sanding drum is snug against sanding sleeve.
Sanding
To sand a workpiece, do these steps:
1. Turn spindle sander ON
and allow it to reach full
speed.
2. Using both hands to maintain control of the
workpiece, guide the workpiece against the rotation
of the spindle, as shown in
Figure 13
. DO NOT force
the workpiece against the sanding sleeve. Allow the
machine to do the work.
Sanding
Sleeves
Sanding
Drums
Table
Inserts
Spindle
Washers
1
⁄
2
" N/A
1
⁄
2
"
5
⁄
8
"
3
⁄
4
"
3
⁄
4
"
3
⁄
4
"
3
⁄
4
"
1" 1" 1"
7
⁄
8
"
1
1
⁄
2
" 1
1
⁄
2
" 1
1
⁄
2
" 1
3
⁄
4
"
2" 2" 2" 1
3
⁄
4
"
3" 3" 3" 1
3
⁄
4
"
Figure 11 . Sanding components table.
Figure 12 . Removal/installation order
of sanding drum components and table
inserts.
Spindle
Sanding
Sleeve
Spindle
Washer
Spindle
Hex Nut
Sanding
Drum
Table
Insert
Base
Washer
Figure 13 . Sanding workpiece.
Spindle
Rotation
Sanding Direction