Shop fox W1742, Руководство по вставке

Страница: 10 / 90

-10-
Model W1742H (For Machines Mfd. Since 01/20)
SE
TU
P
Inventory
Figure 2. Inventory.
A
B
D
E
F
C
SETUP
Unpacking
This machine has been carefully packaged for safe
transportation. If you notice the machine has been
damaged during shipping, please contact your authorized
Shop Fox dealer immediately.
Box Inventory (Figure 2) Qty
A.
Planer .......................................................1
B. Dust Hood ...................................................1
C.
Caster Assembly ...........................................1
D. Foot Lifting Lever and Pin ...............................1
E.
Handwheel and Handle ...................................1
F. Extension Wings ............................................2
Tools & Spare Inserts (Figure 3) Qty
G.
L-Wrench Torx T-20 ........................................2
H. Driver Bit Torx T-20 .......................................2
I.
Indexable Inserts 15 x 15 x 2.5mm .....................5
J. Flat Head Torx Screws T20 M6-1 x 15 ..................3
K.
Hex Wrenches 2.5, 3, 4, 6mm ......................1 Ea.
L. Open-End Wrenches 8/10, 14/17, 17/19mm .....1 Ea.
Hardware (Not Shown) Qty
• Flat Washers 8mm (Wing) ................................6
• Lock Washers 8mm (Wing) ...............................6
• Hex Bolts M8-1.25 x 30 (Wing) ..........................6
• Set Screws M8-1.25 x 20 (Wing) .........................4
• Cap Screws M8-1.25 x 20 (Dust Hood) .................3
• Hex Bolts M6-1 x 10 (Dust Hood) ........................3
• Flat Washers 6mm (Dust Hood) .........................6
• Hex Nuts M6-1 (Dust Hood) ..............................3
• Key 4 x 4 x 20 (Handwheel)..............................1
• Bushing (Handwheel)......................................1
• Hex Nut M12-1.75 (Handwheel) .........................1
• Flat Washer 12mm (Handwheel) ........................1
H
I
G
J
Figure 3.
Tool and spare inserts inventory.
K
L
When ordering replacement parts,
refer to the parts list and diagram in
the back of the manual.
Some hardware/fasteners on the
inventory list may arrive pre-installed
on the machine. Check these locations
before assuming that any items from
the inventory list are missing.
The following is a list of items shipped with your machine.
Before beginning setup, lay these items out and inventory
them.
Note: If you cannot find an item on this list, carefully
check around/inside the machine and packaging materials.
Often, these items get lost in packaging materials while
unpacking or they are pre-installed at the factory.