Shop fox W1701W, Руководство пользователя

Страница: 18 / 56

-16-
Model W1701W (For Machines Mfd. Since 1/16)
SE
TU
P
Assembly
Figure.9..
Attaching cross bars to stand
side.
To.assemble.the.shaper,.do.these.steps:
1..
Lay one stand side on the ground, and attach the
cross bars with (4) M8-1.25 x 10mm carriage bolts,
8mm flat washers, and M8-1.25 hex nuts, as shown
in Figure.9. DO NOT fully tighten the nuts and bolts
at this time.
2..
Attach the second stand side to the assembly.
Note
: At this point, the assembly will be somewhat
wobbly. Have an assistant hold the assembly in
place while you attach the nuts and bolts.
3..
Place the shaper table upside down on two sturdy
blocks that are at least 3
1
⁄
2
" off the ground, as
shown in
Figure.10
. Make sure the spindle DOES NOT
touch the ground, or the weight of the shaper may
damage the spindle.
4..
Place the stand assembly on the shaper. Attach it
with (4) M8-1.25 x 10mm carriage bolts, 8mm flat
washers, and M8-1.25 hex nuts, as shown in
Figure.
10 .
5.. Have an assistant help you turn the shaper unit over.
6.. Level the shaper, then tighten all of the assembly
bolts on the stand.
NOTE: Sheet steel will often “spring” after it has
been fabricated at the factory, occasionally making
it difficult to line up precisely with other parts
without a bit of effort. Do not be surprised if the
stand requires a bit of “persuasion” to fit together.
On the other hand, if the parts just do not seem to
work together, try switching parts around (such as
the tie bars).
7.
Using (4) M8-1.25 x 20 Phillips head screws and 8mm
flat washers, attach each fence face to the fence
mount brackets, as shown in
.Figure.11.
Figure.10.
Attaching stand to shaper unit.
Figure.11.
Fence attached to fence mount
bracket.
x 4
x 4
x 4