Shop fox W1701W, Руководство пользователя

Страница: 15 / 56

-13-
Model W1701W (For Machines Mfd. Since 1/16)
SE
TU
P
Inventory
Figure.6.
Component inventory.
H
I
J
K
L
E
F
G
The following is a list of items shipped with your machine.
Before beginning setup, lay these items out and inventory
them.
Note: If you cannot find an item on this list, carefully
check around/inside the machine and packaging materials.
Often, these items get lost in packaging materials while
unpacking or they are pre-installed at the factory.
Box 1 (Figures 5–7) Qty
A. Shaper Assembly ...........................................1
B. Spindle Assembly w/Spacers .............................1
C. Stand Sides .................................................2
D. Stand Cross Braces ........................................2
E. Fence Assembly ............................................1
F. Table Insert 1
3
⁄
4
"...........................................1
G. Table Insert 1
3
⁄
8
"...........................................1
H. Fence Faces ................................................2
I. Safety Guard ...............................................1
J. Safety Guard Shaft Post ..................................1
K. Safety Guard Attachment Bar ...........................1
L. Miter Gauge ................................................1
M. Rubber Feet M8-1.25 x 15 ................................4
N. Star Knobs M8-1.25 (Fence) ..............................2
O. Starting Pins ................................................2
P. Spindle Wrench 26mm ....................................1
Q. Shaper Bit Collet
1
⁄
2
" ......................................1
R. Router Bit Collet
1
⁄
4
" ......................................1
S. Collet Nut ...................................................1
T. Hex Bolts M12-1.75 x 40 (Table Spacer) ...............5
U. Spacers
1
⁄
2
" (Table Spacer) ...............................7
Included Hardware (Not Shown)
• Carriage Bolts M8-1.25 x 10 (Stand) .................. 16
• Flat Washers 8mm (Stand) ............................. 16
• Hex Nuts M8-1.25 (Stand) .............................. 16
• Fender Washer 8mm (Miter Gauge) ....................1
• Hex Bolts M8-1.25 x 12 (Safety Guard) ................2
• Phillips Head Screws M8-1.25 x 20 (Fence) ...........4
• Flat Washers 8mm (Fence) ...............................6
• Phillips Head Screws M4-.7 x 10 (Safety Guard) ......2
• Hex Nuts M4-.7 (Safety Guard) ..........................2
Figure.5.
Shaper assembly and body.
A
C
D
B
Figure.7.. Hardware inventory.
U
M
N O
P
Q
R
S
T