-27-
Model W1701 (Mfd. Since 12/21)
O
PE
R
ATI
O
NS
To install cutters and rub collars, do these steps:
1.
DISCONNECT MACHINE FROM POWER!
2.
Slide cutter(s) and rub collars onto spindle in correct
orientation for intended cut.
3.
Install keyed safety washer and nut, as shown in
Figure 27
.
Figure 27.
Placing keyed safety washer.
Figure 28.
Tightening spindle nut.
CUTTER FLY-APART HAZARD!
Always use keyed safety washer! Lock tang on this
washer prevents shaper cutter/bit from loosening
spindle nut during operation.
4.
Thread on and tighten down spindle nut with
provided wrench, while holding spindle at top with
another wrench, as shown in
Figure 28
.
5.
Make sure cutter rotates freely in correct direction
needed for cut (in most cases this is FWD direction
on FWD/REV switch, which is counterclockwise on
spindle).
6.
Install applicable safety guard(s).
AMPUTATION/LACERATION HAZARD!
Accidental contact with cutter
during operation will remove parts
of fingers or large chunks of flesh.
Safety guard greatly reduces this
risk and must always be used when
operating this machine!
Keyed
Safety
Washer