ShockWatch SpotBot Cellular, Руководство по эксплуатации продукта

Страница: 13 / 29

4. HOW TO USE YOUR SPOTBOT
13
This document is written and published by ShockWatch, Inc. All rights reserved. No Portion of this document
may be copied, reproduced or transcribed without express consent of ShockWatch. ShockWatch reserves the
right to change this document and its products. Every effort has be made to ensure accuracy in content.
PRODUCT MANUAL
Now that your SpotBot is configured, you can begin a Trip
by holding Button A (Start/Stop) down for 1 sec.
You should see 2 green LEDs (On and Sending) light up.
The Left LED indicates the Trip is ON, while the Right LED
indicates the device is transmitting information.
The SpotBot will send a message (Sending green LED flashing) to inform the SpotSee
platform that a Trip has started.
A new Trip fails to start if:
• You see a red LED when trying to start a Trip.
(This means something is wrong with the device configuration.
Please refer to
Configure your SpotBot section and follow the
steps carefully.)
–OR –
• You see only one green LED (On) or green and red (Alarm)
if an alarm was issued on a previous Trip. (this means a Trip is
already started, you can choose to stop it or leave it on)
A. START A TRIP
A good way to verify if the Trip is active is to produce an alarm. Place a notepad
on your desk and drop the SpotBot from 2-3” above the notepad. You will see all
3 LEDs flash if the Trip is started and no LEDs if the Trip is not started.
TIP