FRONT PANEL
FRONT PANEL
1. POWER ON SWITCH
The power switch turns the unit on and off. The LED will illuminate red to indicate that the switcher is ON and is receiving power
2. SOURCE DEVICE STATUS LED DISPLAY
Channels 1 to 4 shown from LED display illuminates red to indicate that a video source is present on that input.
3. SOURCE DEVICE SELECT BUTTONS
A separate output 1 thru 8 source select buttons are provided for each destination.
4. SOURCES SET BUTTONS
Setup the input sources 1 ~ 4 channels
5. IR SENSOR
The IR sensor receives IR commands from the supplied remote controller.
6. 19 INCH EAR MOUNT PAIR
19 inch 1 RU {1 3/4”) rack mount brackets. Part number: 1U-440L
De-press “Select” button until the desired Output channel appears. Then immediately depress the “Set” button to lock in that channel.
For example:
To select input source #2 to destination output #1, you would depress the “Select” button in the fi rst channel until the display
changes to “ 2.” Then immediately depress the “Set” button.
OPERATING THE UNIT
Once you have connected the switcher as described above, you must be certain that the input are being fed appropriate signals and are
not suffering from signal loss due to cabling problems or problems with the source device.
If the input signals to the switcher are appropriate, switch the power switch to <ON> and you should see and hear the signals on the
devices you have connected to the various output connectors of the switcher.
POWER AND CONNECTIONS
This unit is not disconnected from the AC power source as long as it is connected to the wall outlet. The off state for this unit is called
standby mode. In standby mode the unit is designed to consume a reduced quantity of power compared to normal operating modes.
When it is not using the unit for a long period of time, insure that the AC power cord is disconnected from the wall outlet.
The AC wall outlet should be installed near to the unit and be easily accessible.
Do not plug in or attempt to operate an obviously damaged unit.
3