Shindaiwa T272, Инструкция по эксплуатации

Страница: 9 / 16

9
Assembly
New Cutting Attachment Shield
ASSEMBLY
Install the Cutting
Attachment Shield.
1. Insert the cutting attachment
shield between the outer tube
and the cutting attachment shield
mounting plate. See Figure 5.
WARNING!
NEVER
operate the unit without
the cutting attachment shield
installed and tightly secured!
CAUTION!
Make sure the clamp screw and
retaining nut are securely tight-
ened before tightening the four
socket-head cap screws.
NOTE:
It may be necessary to loosen the re-
taining nut and clamp screw to adjust
cutting attachment shield mounting
plate.
2. Fit the two shims and the bracket
over the outer tube and loosely
install the four socket-head cap
screws.
Sub-Shield.
(when trimmer head is in use)
1. Attach the shield extension to the
cutting attachment shield.
WARNING!
NEVER
use this machine without
sub-shield when using a trimmer
head.
CAUTION!
Make sure the sub-guard is
completely hooked at the hook
receiver.
Sub-shield
Hook
Hook
Receiver
Cutting Attachment Shield
3. Tighten the four socket-head cap
screws to secure the cutting attach-
ment shield.
Shim
Shim
Nut
Upper Clamp
Cutting
Attachment
Shield
Cutting Attachment
Shield Mounting
Plate
Socket-head
Cap Screws
Figure 5