Shindaiwa M231, Руководство владельца/оператора

Страница: 14 / 28

OPERATION
13
Idle the engine briefly before stopping
(about 2 minutes), then slide the igni-
tion switch to the “O” (engine OFF)
position. See Figure 12.
Stopping the Engine Adjusting Engine Idle
Idle Adjusting
Screw
Figure 12 Figure 13
Slower
Faster
The engine must return to idle speed
whenever the throttle lever is released.
Idle speed is adjustable, and must be set
low enough to permit the engine clutch
to disengage the cutting attachment.
WARNING!
The cutting attachment must
NEVER rotate at engine idle! If
the idle speed cannot be adjusted
by the procedure described here,
return the unit to your Shindaiwa
dealer for inspection.
Idle Speed Adjustment
1. Place the unit on the ground, then
start the engine and allow it to idle
2-3 minutes until warm.
2. If the attachment rotates when the
engine is at idle, reduce the idle
speed by turning the idle adjust-
ment screw counter-clockwise.
See Figure 13.
3. If a tachometer is available, the engine
idle speed should be final adjusted to
2,750 (±250) rpm (min
-1
).
4. Carburetor fuel mixture adjust-
ments are preset at factory and
cannot be serviced in the field.