18
Before you start
Assembly
Install the wheel
Replacing the adapter
Install the adapter that fits the inside diameter of the cutting
wheel. When shipped, an adapter with an outside diameter of
20 mm is mounted. If the inside diameter of the cutting wheel
to be used is 22 mm or 25.4 mm, replace the adapter as fol-
lows.
1. Insert the bar tool.
2. Rotate the drive shaft until the hole in the large pulley and
the bar tool aligned.
3. Unscrew wheel mounting bolt with the 19 mm end of the box
wrench or your fingers. Remove wheel bolt and outer flange,
leaving inner flange in place.
4. The adapter is held to the drive shaft with a snap ring. Insert
a tool like a small slotted screwdriver in the gap and remove
the snap ring.
5. Replace with an adapter that fits the inside diameter of the
cutting wheel to be used.
6. Press the snap ring in until it reaches the groove in the drive
shaft and secures the adapter. If the snap ring is deformed,
replace it with a new one.
WARNING
Read the operator's manual carefully to ensure that you assemble the product correctly.
Never perform maintenance or assembly procedures with engine running.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
1. Bar tool
2. Pulley cover
1. Unscrew
1. Snap ring
2. Adapter
3. Drive shaft
1. Adapter
2. Snap ring
3. Outer flange
4. Wheel mounting bolt
Содержание EC741s
