Shindaiwa DGK125F, Руководство владельца и оператора

Страница: 51 / 68

48
Inner Element
Outer Element
Air Cleaner Cap
Vacuator Valve
Air Cleaner
Clip
(3) Air Filter Element Cleaning/Replacement
Remove the air cleaner clips and cleaner cap.
Remove the outer element.
Clean or replace the outer element. Replace by
performing the above procedures in reverse order.
< Note >
 Inner air element must not be reused even if it is
cleaned.
 Replace the inner element when replacing the outer element.
 Always be sure to turn the cleaner cap in the direction
indicated by the arrow.
 Replace the elements earlier if using in an excessively dusty
location.
 Do not add oil as this generator uses a dry element.
 Clear foreign material by pinching the vacuator valve once a
week in normal operating conditions or daily if operating in a
location that is excessively dirty or dusty. Wipe away any dirt
or moisture that has adhered to the parts.
 Never touch the elements for any reason except cleaning.
 The mass air flow (MAF) sensor is installed to the air cleaner inlet duct. Refrain from using
commercially available cleaning agent to remove dust clinging to the sensor; otherwise the
engine output will be reduced.

Outer
Element part no.: P821938 (Isuzu part no.)

Inner
Element part no. : P821963 (Isuzu part no.)

Cleaning the air filter element (outer element)
If dry dust is adhering : Blow compressed air from inside the element.
If carbon or oil is adhering : Replace with new parts.
(4) Draining Water from the Fuel Filter (Pre Filter)
Check/Drain Daily
Drain water when the float (red) inside the cup floats to the
water draining position (bottom of the element).
Place a container under Fuel Filter to catch spilled
water and fuel.
Loosen the air bleeder plug of the fuel filter sufficiently.
Loosen the drain plug on the bottom to drain the water.
When water draining is completed, tighten the drain
plug on the bottom.
Tighten the air-bleeding plug.
Drain plug tightening torque
2 - 3 N ･ m
Air bleeder plug tightening torque
7.9 - 11.7 N
･
m
Clean (Outer element) Every 250 hours
Replace (Inner / Outer element) Every 500 hours
1
2
3
1
2
3
4
5
Pre
Drain Plug
Float (Red)
Water Drain
Level
Air Bleeder
Plug
Fuel Filter
Element
(Pre)