21
WARNING!
Sharpen only the cutting teeth of a
blade. DO NOT alter the contour of
the blade in any way.
WARNING!
Wear protective gloves
when handling or performing
maintenance on the blade.
Round
File
When the cutting edges of the blade
become dull, they can be resharpened
with a few strokes of a file.
In order to keep the blade in balance,
all cutting edges must be sharpened
equally.
Multiple-tooth Circular Blade
Use a round file to maintain a radius of
1 - 1.5 mm (0.04 - 0.06 in.) at the base
of each tooth. Cutting edges must be
offset equally on each side.
Maintain a radius of 0.04 to 1 to 1.5 mm
(0.06 in.) at the base of each tooth. Cutting
edges must be offset equally on each side
Multiple-tooth Circular Blade
Maintenance
(continued)
Blade Sharpening
Adjusting Engine Idle
The engine must return to idle speed
whenever the throttle lever is released.
Idle speed is adjustable, and must
be set low enough to permit the
engine clutch to disengage the cutting
attachment.
WARNING!
The cutting attachment
must NEVER rotate at engine idle!
If the idle speed cannot be adjusted
by the procedure described here,
return the unit to your Shindaiwa
dealer for inspection.
Idle Speed Adjustment
1. Place the unit on the ground, then
start the engine, and then allow it to
idle 2 - 3 minutes until warm.
2. If the attachment rotates when the
engine is at idle, reduce the idle
speed by turning the idle adjustment
screw counterclockwise.
3. If a tachometer is available, adjust
idle. Check Specifications page for
correct idle speed
NOTE:
Carburetor fuel mixture adjustments
are preset at factory and cannot be
serviced in the field.
Idle Adjustment
Screw
Loading Trimmer Line
1. Cut one piece of line to recommended length.
2. Align arrows on top of knob with openings in eyelets.
3. Insert one end of trimmer line into an eyelet, and
push line equal distance through trimmer head.
4. Hold trimmer head while turning knob clockwise to
wind line onto spool until about 13 cm ( 5 in.) of each
line remains exposed.
Trimmer head is now fully loaded and ready for
operation.
1
2
3
4
NOTE:
Trimmer head is pre-wound with 2.4 mm (.095 in.) Crossfire™
trimmer line.
2.0 mm (0.080 in.) dia. - 6 m (20 ft.)
2.4 mm (0.095 in.) dia. - 4 m (14 ft.)
2.7 mm (0.105 in.) dia. - 3 m (10 ft.)
