Shindaiwa AH254, Руководство владельца/оператора

Страница: 9 / 32

9
Cable
Adjuster
4 - 6 mm
(3/16 - 1/4 in.)
Throttle trigger free play
Assembly
(continued)
The throttle trigger free play should
be approximately 4 - 6 mm (3/16 - 1/4
in.). Make sure that the throttle trigger
operates smoothly without binding. If it
becomes necessary to adjust the trigger
free play, follow the procedures and
illustrations that follow.
1. Loosen the air cleaner cover knob(s)
and remove the air cleaner cover.
2. Turn the cable adjuster in or out as
required to obtain proper free play
4 - 6 mm (3/16 - 1/4 in.).
3. Reinstall the air cleaner cover.
Throttle trigger free play
The cutter assembly can be adjusted
to eleven different positions ranging
from 120° to 270° from the outer tube
as shown. Always make sure the latch
lock is securely locked after each
adjustment.
Cutter Assembly Positions
1. Position the hedge trimmer on a
flat, level surface.
2. With your right hand, grasp the
outer tube near the handle. With
your left hand, grip the adjustment
lever on the cutter assembly. With
the index finger of your left hand,
press the latch lock. With your left
thumb, press the latch release.
270°
120°
Various blade
positions
possible
Cutter
Assembly
Positions
IMPORTANT!
The latch lock provides an interlock to
help prevent inadvertent depression of
the latch release.
Latch Release
Adjustment Lever
Press the latch lock
Make sure the latch lock and the latch release
return securely to the locked position
1. With the engine off, install the
blade cover onto the blade.
2. Using the procedures described
above, rotate the cutter assembly
so it is parallel to the tube. Make
sure the latch lock and the latch
release return securely to a locking
position.
3. Make sure the blade cover is in
place on the cutters before storing or
transporting.
Gearcase rotated to the storage/
transportation position
Adjusting for Storage or Transportation
WARNING!
Never run the engine when
adjusting the cutter assembly.
Adjusting for Storage or Transportation
3. While holding the latch release
down, pivot the cutter assembly
away from you using the
adjustment lever until it is at the
desired cutting angle.
4. Release the latch lock and the
latch release. Make sure the latch
lock and the latch release return
securely to the locked position.
5. Remove the cover from the cutter
blade. The engine now may
be started (refer to the section
”Starting the Engine”).
WARNING!
Never run the engine when
adjusting the cutter assembly.
Latch Lock