Shindaiwa 269TCs, Руководство владельца/оператора

Страница: 13 / 26

13
■
Release throttle trigger and allow engine to
idle.
■
Place ignition switch in STOP position.
Note
If engine does not stop, turn choke control knob
counterclockwise to stop engine. Return the unit
to your authorized
shindaiwa dealer to check
and repair ignition switch before starting the
engine again.
■
Familiarize yourself with your chain saw
before you start actual cutting.
■
For this purpose it may be wise to practice
by cutting some small logs or limbs several
times.
■
Do not allow anybody and animal into the
work area. Multiple operators - Keep a safe
distance between two or more operators
when working together simultaneously.
Stopping the Engine
Pre Cutting Test
■
Chain tension should be checked frequently
during work and corrected if necessary.
■
Tension the chain as tight as possible, but
so it can still be pulled easily along the bar
by hand.
Hold the chain just above a dry surface and
open the throttle to half speed for 30 seconds.
A thin line of “thrown” oil should be seen on
the dry surface.
WARNING
Make sure that the engine is shut off
when checking chain tension.
Checking Chain Tension
Chain Lubrication Test
■
After engine starts, allow it to idle for a few
minutes.
■
Pull front hand guard towards the operator
immediately. (Chain brake RELEASED
position)
■
Squeeze throttle trigger gradually to
increase engine revolution.
■
The chain starts moving when the engine
reaches 4400 r min approximately.
■
Ensure proper acceleration and lubrication
of saw chain and guide bar.
■
Do not run the engine at high speed
unnecessarily.
■
Be sure that saw chain stops moving when
throttle trigger is released.
Running
Note
Always loosen clutch cover nut before turning
the chain tension adjusters otherwise clutch cover
and tensioner will be damaged.
Throttle trigger lockout
Throttle trigger
Ignition switch
Throttle trigger