Shinco SPHN12W, Руководство пользователя

Страница: 14 / 16

13
Trouble Shooting
Don
’
t repair or disassemble the unit by yourself, unsuitable repair may make the quality-protected card in
vain, and even cause damage to the user or his/her possession.
Trouble Reason Solution
No power supply Power-on and turn on the unit.
FL and Water-full indicator
illuminate
Drain out the inner stored water
Timer function is active Cancel Timer function
The unit
doesn’t work
Room temperature too low or too
high?
Suggesting ambient temperature
between 7-35
℃（
44-95
℉）
In direct sunlight Draw the curtains
Windows or doors open, many
people or a heat source in the
room
Close windows and turn on another air
conditioner
Filter is very dirty Clean or change the air filter
Air inlet or air outlet is blocked Clear out the stemming
The unit does
not seem to
perform
Room temperature is lower than
setting temperature
Change the setting temperature
The unit noise
is high
The unit is not put on flat place
Put the unit on flat and hard
place( reduce noise)
Compressor
doesn’t work
Heat-exceeded protection is
active
Re-start the unit 3 minutes later till the
temperature low down.
The distance is too far.
Control panel hasn’t received the
signal from remote control.
Let the remote control near the unit and
make sure it aims at the air-outlet
grille
Remote
control doesn’t
work
The batteries run out. Change the batteries
CH 01 on
LCD
Room temperature is abnormal
check room temperature sensor or
relevant circuit
CH 02 on
LCD
Coil temperature is abnormal
check coil temperature sensor or
relevant circuit
If the solutions above don
’
t function for the troubles, please contact with special service agent for help.