20
INSTALLATION/REMOVAL
E Type
5.
Adjust the gap between the guide and chain.
Turn the adjuster and adjust until the following conditions are met.
• The gap between the chain and the inside surface of the guide outer side is 0 - 0.5 mm
• The gap between the guide and adjuster is 3 mm or less
B
A
B
A
0 - 0.5 mm
Chain
Guide
3 mm or less
Adjuster
Adjuster
NOTE
•
If the two conditions above are not met, re-check the necessity of the spacer(s) based
on the instructions in step 2.
6.
Secure the guide.
This completes the installation process for the E type.
Guide mounting bolt
2 - 3 N·m
