Adjusting the cable tension
Adjusting the low limit
After taking up the initial slack in the inner cable, re-secure to the rear derailleur.
Pull
1.
Cut off the excess length of inner cable, then install the inner end cap.
2.
While turning the crankset, operate the lever to shift to the largest sprocket.
1.
Adjust by turning the low limit screw.
Adjust so that the center of the guide pulley is aligned with the center of the largest sprocket.
* The position of the low limit screw differs depending on the model.
Low limit screw
Example
Guide pulley
Largest sprocket
2.
Adjustment
Right-hand lever adjustment
15
