Shimano ALFINE BL-S705-L, Руководство дилера

Страница: 49 / 95

49
CONNECTION OF THE ELECTRIC WIRES
Connection to the dual control lever
„
Connection to the dual control lever
When routing the electric wires, allow enough looseness in the cable so that the dual control lever, shifting switch installation position can be adjusted
and so that the handlebars can be turned fully to the left and right.
The electric wire for the dual control lever can be wound around the handle when the bar tape is wrapped.
(B) (z)
(A)
Open up the bracket cover and lift up
the connector cover.
Use the TL-EW02 to connect the
connector of the electric wire to the
E-TUBE port on the lever side.
(z)
The remaining terminal can be
used for an additional satellite
switch or PC linkage device.
(A)
TL-EW02
(B)
Bracket cover
NOTICE
•
When the handle is gripped or the bar tape
is wound, the electric wires may be pulled
out. By allowing sufficient wire length,
accidental disconnection can be prevented
after winding the bar tape.
•
This length margin of electric wire is also
necessary to open up the bracket cover
when an additional satellite switch and PC
linkage device are connected.