7
inspected while in this position.
[Assembly]
1) With the unit cover (B5) as the base, use screw P4 M4 × 8 (7 screws) to tighten.
* With the unit cover (B5) rear screw as the base, align with the center of the pan supporter axis
and the 15.5-dia. hole to amount the other screws. (Fig. 2-7)
* Mount the unit cover (B5) so that the cable is flat. At this time, be careful to avoid pinching the
cable.
* Check that there is no gap between the base ASSY (B1) and the unit cover (B5).
Fig. 2-7
Fig. 2-8
2) With the case ASSY (3) lifted up, insert the connector into the switch board ASSY (C4), and set the case
ASSY (3) into the base unit ASSY (2).
* Be careful to avoid damaging the power board ASSY (B4) and cable when covering the base
unit ASSY (2) with the case ASSY (3).
* Be careful to ensure that the case ASSY (3) does not touch the pan supporter axis when
covering the base unit ASSY (2) with the case ASSY (3).
* Check the connector connection conditions on the power board ASSY (B4).
3) Tighten the case ASSY (3) and base unit ASSY (2) in two locations in back (bolt P4 M4 × 25) and two
locations on the bottom front side (P3 M4 × 20).
4) Attach the screw covers (B24) in two locations on the back of the balance.
* When attaching the screw covers (B24), insert the protrusion on one side of the screw cover
(B24) into the case (C1) hole and then push down on the top of the screw cover (B24) to attach.
* Attach so that the screw cover (B24) hole is on the back side.
Fig. 2-9
Fig. 2-10
Fig. 2-11
5) Mount the rear cover (13) (truss M3 × 5 (4 screws)).
6) Align the anti-blow ring (11) and the center of the pan supporter axis, and mount the anti-blow ring (11) and
wind shield plate (12). (Fixing screw: Anti-blow ring (11)
→ Screw P3 M2.5 × 6 (2 screws), Wind shield plate
(12)
→ Screw P4 M3 × 6 (2 screws))
Fig. 2-12
Unit cover assembly
base screw
Align with the center.
Screw cover
Hole
Protrusion
Hole
Align with the center.
Wind shield plate
fixing screw
Anti-blow ring fixing
screw