Quick Access
The
Quick Access
function allows you to quickly switch from the currently selected program to the first program in
the UD bank. We recommend that you save your most frequently used program to the first slot in the UD bank.
To recall or exit the Quick Access program, double-tap the ON footswitch. If the ON LED is glowing green, it means
the Quick Access program is active. If the Quick Access program is active but the pedal is bypassed, the ON LED
flashes briefly to indicate that the Quick Access program will be recalled once you engage the effect.
When the Quick Access is active, control values aren’t updated unless you turn a knob or move a switch. If you alter
the Quick Access program without saving, the ON LED will flash briefly to indicate that the altered preset hasn’t been
saved. If you exit the Quick Access program without saving, the pedal will use the last saved Quick Access settings
the next time you recall it. Saving a program to the Quick Access slot is done in the same way as to any other slot
(see the
section for instructions).
The Quick Access function can be assigned to the CTRL input in
or via the config file. You can also disable
the Quick Access function there.
External Parameter Control
The
CTRL
stereo input allows for external control over the pedal’s parameters. This input has several operation
modes:
1.
Passive controller
(normally open momentary switch). Footswitch functions are replicated. TIP corresponds to
the TAP/ALT footswitch, RING corresponds to the ON/HOLD footswitch.
2.
Full MIDI control
(Type A). This mode is active by default.
3.
S-trigger
(“short circuit trigger”). Analog trigger/gate with the same polarity as the pedal’s. This is the
recommended trigger type. TIP controls the TAP function, RING controls the HOLD function.
4.
V-trigger
(“voltage trigger”/”positive trigger”). Analog trigger/gate with polarity opposite to the pedal’s. If no
external signal is coming into the CTRL input, the LED will light up, and some of the pedal’s functions will be
inactive. Those functions become active as soon as a control signal is connected. TIP controls the TAP function,
RING controls the HOLD function.
Use this trigger type if you have no S-trigger source or if you prefer V-triggers
for other reasons.
5.
Passive expression pedal
. Provides external control over the DECAY knob. Expression pedals with TS (mono)
connection are recommended. More expression pedal functions will be implemented later.
6.
Passive controller
(normally open momentary switch) or analog S-trigger. TIP controls the Quick Access
function, RING controls the TAP function.
Setup Mode
By default, the pedal powers up in standard mode. To access parameter settings through the pedal’s UI elements, you
need to enter
Setup Mode
.
Entering Setup Mode
: Connect the power to the pedal while holding down the TAP/ALT footswitch. Both LEDs will
glow purple for 5 seconds. After that, the UI will display the current settings.
Saving & Exiting Setup Mode:
Press and hold the ON footswitch for over 5 seconds. The pedal will return to standard
mode (the ON LED will stop glowing). All changes to the pedal’s settings will be saved as soon as you exit Setup
Mode and will be immediately applied.
Exiting Setup Mode (Without Saving):
If you wish to exit Setup Mode without saving, unplug the power from the
pedal, then plug it back in.
To revert to default settings, use
You can also edit the config file (USER.SET) over USB.
