Shibaura N843, Руководство по ремонту

Страница: 42 / 75

4-6 109823 2/09
Crankshaft pulley
Install the key into the crankshaft, and install the crankshaft
pulley and tighten with the nut.
Injection pump assembly
1. Install the shim, which was removed during
disassembly, connect the control rack of the injection
pump and link, and install the snap pin.
2. Tighten the injection pump bolts and nuts.
Notes: 1.
When shim is not required, use a light
coat of silicone before installing.
2.
The injection timing varies about 2º
with 0.012in (0.3 mm) of shims.
3.
Use a combination of shims (0.020 in
(0.5 mm)) with beading and a shim
(0.020 in (0.5 mm)) without beading
when you need adjusting shims more
than 0.0394 in (1.0 mm).
‘Oil filter
Coat the mounting surface with a small quantity of oil and
tighten by hand.
Engine stop solenoid
Tighten the engine stop solenoid lightly with pliers.
Crankshaft pulley torque
82.6-88.9 lbf•ft (118–127 N·m) {12–13 kgf·m}
Injection pump torque
73.47-100.0 in•lb
f
(8.3–11.3 N·m) {0.85–11.5 kgf·m}
Injection timing adjusting shim
Thickness in(mm) Part code
0.008 (0.2) 131437590
0.012 (0.3) 131437600
0.016 (0.4) 131437610
0.020 (0.5) 131437620
0.020 (0.5) *131437630
* Without beading
Fig. 4-15
Fig. 4-16
Snap pin
Injection pump
Shim
Link