Shibaura N843, Руководство по ремонту

Страница: 62 / 75

5-16 109823_2/09
c. To check brush holder assembly for grounds,
touch one probe of a circuit tester to holder plate
and the other probe to each of insulated holders.
Replace brush holder assembly if any continuity is
noted.
d. Overrunning clutch and pinion gear. While holding
clutch housing, rotate pinion. Pinion should rotate
smoothly in one direction (not necessarily easily),
but should not rotate in opposite direction. If the
clutch does not function properly, replace it. If
pinion gear is worn or burred, replace it.
Note: Overrunning clutch should not be cleaned
with grease dissolving solvents, since
these would dissolve the lubricant in the
clutch mechanism.
Reassembly and adjustment
To reassemble the starter, follow the reverse of
disassembling procedure.
1. Apply grease to the following parts during assembly:
(see page 5-16, Fig. 5-33)
a. Sleeve bearing and ball.
b. Sleeve bearing in internal gear.
c. Sleeve bearing in rear bracket.
d. Gear shaft
e. Sliding surface of lever and overrunning clutch.
f. Armature shaft gear, internal gear and planetary
gears.
g. Sliding surfaces of pinion and front bearing.
2. ) Armature shaft end play: no adjustment.
3. Pinion position adjustment.
After completing reassembly, check pinion position to be
sure that it is between 0.020 and 0.079 (0.5 and 2.0mm). To
adjust, proceed as follows:
a. Connect the starter to a battery, as shown in page
5-16, Fig. 5-34. Close switch. This will shift pinion
into cranking position.
Fig. 5-32
Fig. 5-33
a
b
c
e
g f
d
Fig. 5-34
Terminal: S
Switch
Battery