Sherwood SBD-15, Руководство пользователя

Страница: 18 / 22

18
Section 8: Maintenance & Care
Removing and Inserting the
Sanding Belt
1.
Unscrew the cover locking knob and remove
the acrylic glass cover.
2.
Unscrew both philips screws that fixed the
sanding belt bracket cover.
3.
Remove the cover. The rear drive wheel
is spring supported. Press the adjusting
knob to push the wheel slightly forwards in
order to remove the sanding belt out of the
wheels.
4.
Insert the new sanding belt onto the wheels.
5.
Turn the belt with your hand and observe, if
the belt runs in the middle of the wheels or if
the belt moves sideward. Turn the adjusting
knob to adjust the position of the wheel and
to correct the run of the sanding belt.
6.
Attach the sanding belt bracket cover again
and tighten the cover with the Philips
screws.
7.
Place the acrylic glass cover onto the bracket
cover and fix them with the cover locking
knob.
Cleaning
•
Do not clean the belt and disc sander with
water or aggressive cleaner but only with a
dry cloth or a brush.
•
Although attaching a dust collection,
sanding dust may accumulate behind the
bracket cover. Therefore remove the cover
as described from time to time and clean the
interior with a brush or vacuum cleaner.
•
If the belt and disc sander has technical
damage, immediately stop using the
machine.
•
Maintenance that exceeds removing the
sanding disc or the sanding belt, should
be carried out by a qualified technician or
contact customer service.
Removing the Sanding Disc
The sanding disc is glued to the sanding dish.
1.
To remove the sanding disc, detach the
sanding dish table and the sanding dish
guard.
2.
Carefully remove the used sanding disc.
3.
Remove remaining adhesive residues.
4.
Stick a new sanding disc of the same
diameter onto the dish.
5.
After fixing a new sanding disc, attach the
sanding dish guard and the sanding dish
table onto the sander, as explained above.
Maintenance & Care