Sherwood SBD-15, Руководство пользователя

Страница: 15 / 22

15
Adjusting the Sanding Table
(Fig. 5)
For most work, mount the sanding table to 90°
angle to the sanding belt. The
sander is equipped with a positive stop in order
to enable quick positioning the
sanding table to 90° angle to the sanding belt.
Adjust the positive stop as follows:
1.
Loosen the locking lever and position the
table to visual judgement to 90°.
2.
Use a right-angled triangle.
3.
Place the one leg of the triangle, as shown,
on the table and hold the other leg against
the sanding belt. Check, if the table is in
90° angle to the belt. Adjust the table if
necessary.
4.
If the table surface is in 90° angle to the
belt, tighten the Hex Socket Screw on the
upper end of the table as far as possible.
The bottom side of the screw should slightly
touch the plate underneath the table. Now
you can reposition the table to exactly 90°
angle without new adjustment.
5.
The sanding table can be mounted in
different angles to the belt. Loosen the
locking lever and tilt the table up to the
required angularity. The table edge is
situated in front of the belt but too far from
the belt.
6.
Therefore, slowly push the table in direction
to the belt observing the required incline.
For safety use, the gap between the table
edge and the belt should not be higher than
2 mm.
7.
After adjustment, tighten the locking lever
again.
Triangle
Locking
Lever
Allen Wrench
Hex Socket
Screw
Fig. 5
Set Up & Operation