Sherwood RD-6505, Руководство по эксплуатации, Страница: 27 / 42

System Setup
27
E
N
G
L
IS
H
• The setup menu is displayed on the fluorescent display and allows you to perform the setup procedures easily. In most
situations, you will only need to set this once during the installation and layout of your home theater, and it rarely
needs to be changed later.
The setup menu consists of 5 main menus ; system, input, speaker setup, CH level and parameter. These menus are
then divided up into various sub-menus.
■
Navigating through the setup menu
• The explanations here assume you are using the buttons on the remote control when performing the setup menu
operation. However, you can use the buttons on the front panel as well.
The buttons on the front panel correspond to those on the remote control as shown below.
SETUP ENTER / MEMO PRESET
TUNE
• The setup menu will be shown.
• To turn the menu off, press this button again.
• When selecting "SYSTEM", see "SETTING THE
SYSTEM" on page 29.
• When selecting "INPUT", see "SETTING THE INPUT"
on page 31.
• When selecting "SPK SET", see "SETTING THE
SPEAKER SETUP" on page 32.
• When selecting "CH LEVEL", see "SETTING THE CH
LEVEL" on page 36.
• When selecting "PARAMTR", see "SETTING THE
PARAMETER" on page 38.
• When selecting "EXIT", the setup menu will be turned
off.
1.
Turn the setup menu on.
2.
Select the desired menu using the CURSOR
UP(
▲
)/ DOWN(
▼
) buttons.
3.
Confirm your selection.
RD-6505(E)_ENG_100517_RD-6505(E)_ENG 2010-05-24 오전 9:59 페이지 27