8
Avoid use in environments with high humidity, especially in situations of occurrence of dew on the metal parts.
In the case of dew on the metal parts, eg. The device after the cold into a warm room, wait until it is completely dry and warm the device to room
temperature. Starting in these conditions, cold welding can cause damage. It is recommended that in the event of welding operation outdoor place it
under a roof to protect against adverse weather conditions. MMA device 200 should be operated under the following conditions:
-
changes in the effective value of the supply voltage is not greater than 10%
-
ambient temperature of from -10 ° C to + 40 ° C
-
Atmospheric pressure 860 to 1060 hPa
-
relative humidity of the atmosphere is not more than 80%
-
height above sea level to 1000m
13. MAINTENANCE INSTRUCTIONS
As part of the everyday operation of the welder must be kept clean, check the connection status and the status of external electrical wires
and cables. Regularly replace consumables.
Periodically clean the inside of the device by purging with compressed air to remove dust and chips from metallic plates, and the control wires and
electrical connections. Not less than once every six months should be a general review of the status and electrical connections, in particular:
-
state of shock protection
-
the insulation
-
the state security
-
the operation of the cooling system
14. INSTRUCTION STORAGE AND TRANSPORT
The device should be stored at -10 ° C to + 40 ° C and relative humidity 80% free of corrosive fumes and dusts. Transportation of packaged devices
should be covered means of transport. For transport the packaged unit must be secured against slipping and ensure the correct position.
15. COMPLETE SPECIFICATION
1. Source MMA 200
1 piece.
2. Connect the electrode holder
1 piece.
3. Earth cable with a clamp
1 piece.
4. Manual
1 piece.
5. Packaging
1 piece.
Содержание MMA 200
Страница 1: ...V2 5 08 16 26 USER MANUAL WELDING RECTIFIER Inverter MMA 200 ...
Страница 9: ...9 16 ELECTRIC SCHEME ...