SHERCO ST 125, Руководство по ремонту

Страница: 15 / 51

13
ST SERIES
CYCLE PARTS
❱❘
REAR
2.1 Replacement of wheel bearings
•
Hold the wheel axle on the left side and
loosen the nut on the right side
•
Remove the axle from the left.
•
Take out the wheel and remove the
spacers.
Rear wheel tightening : 100 Nm
•
Heat the hub at the bearing seat
using a heat gun.
•
Extract the bearings using a ø 20
flush.
•
Replace the bearings with new ones,
reference 0175.
2.2 Disc replacement
•
When replacing the rear brake disc,
apply when reassembling the Loctite
243 and on the screws and tighten to a
torque of
12 Nm ..
•
Reassemble the assembly following the
reverse process and lightly greasing the
rear wheel axle.
WARNING
Using a caliper, check the size of the internal spacer reference 5931 on the rear wheel
and replace it if necessary.
Minimum tolerance: 118.5mm