SHERCO CityCorp Enduro Supermotard 4T 125CC, Руководство пользователя

Страница: 55 / 112

55
Engine Oil
Check the oil level (stop the engine and wait
a few minutes)
1. Stand the vehicle perpendicular to the ground.
2. Remove the cap (1). If the level is between
the two marks gauge, the level is correct.
3. If the level is low, add the correct amount of
the approved oil to bring it to the corect level.
4. Replace the cap.
Drive chain adjustment
- To check the drive chain for slack:
1. The wheels have to be on the ground.
2. The motorcycle has to be vertical.
3. No one can be on the motorcycle.
- If the vertical deflection is between 25 and 40
mm the chain must be adjusted.
1. Loosen the rear wheel axle nut (1).
2. Adjust the deflection with the nuts adjusters
systems (2) and (3) on both sides of the motor-
cycle until the chain deflection is between 12 and
24 mm. Make sure that the adjusters are in the
same position on both sides.
3. Tighten the rear wheel axle nut (1) to 90 Nm.
Oil change
1. Warm up the engine and then shut it off.
2. Place the vehicle over an approved receptacle.
3. Remove the oil drain plug (3).
Note: the picture does not look like the drain plug.
4. Once the oil has completely drained, repla-
ce the drain plug (3) and torque it to 18 Nm.
5. Remove the cap (2) and fill the
engine with the approved amount.
1
2
1 3 2
We recommend that you
lubricate the chain with
adapted chain lubricant
3