Sherbourn PT-7030, Руководство пользователя

Страница: 29 / 53

Page 24
PT-7030: User Manual
9. Random Button
When playing music from a USB stick, this button causes songs to be played in random order
(“shuffle mode”).
10. Playback Buttons
These buttons provide basic playback controls for audio played from a USB stick.
11. Mode Control Buttons
The 2-CH Button changes the audio mode to Stereo, Down-Mix, or Bypass.
The PLCM Button toggles the audio mode to Pro Logic Cinema or Music.
The SUR+ button allows you to view or change the current surround mode and configure the
automatic dynamic range control. Press the Sur+ button to view the information; while the
information is displayed, the Lt and Rt navigation buttons switch between surround modes and the
Dn navigation button switches between dynamic range options.
12. Sel Button
Allows you to configure options for each zone. Press the Sel button repeatedly until the desired
zone appears in the display. Once the desired zone is selected, you have 10 seconds to make
changes. (Press an Input Selector button to choose a different input, or use the and
Volume -- Buttons to change volume for the zone.)
13. Input Selector Button
Each button directly selects an Input.
Note: You must configure the specific video and/or audio source for each input.
14. [UNUSED]
15. Multi (Input Selector Button)
Selects the 7.1 channel (“Multi-Channel”) unbalanced audio input.
Note: The remote control for the PT-7030 can be configured to use an alternate set of IR
control commands (to avoid conflicts with the codes used by some other device). The
default command set is Set 1, and the alternate command set for the main zone is Set 2. To
configure the remote control to use IR Command Set 2, press the In2 and Number 2 buttons
on the remote AT THE SAME TIME. Then point the remote control at the PT-7030 and hold the
Number 2 button for at least five seconds (a message will display on the front panel “AUD ID:
-->2” to acknowledge the change). To reset the PT-7030 and remote to use Set 1, repeat the
procedure using IN2 and the Number 1 button.
Note: The remote control for the PT-7030 can be configured to directly control Zone 2, Zone
3, or Zone 4. (This feature could be used to enable you to put IR repeater receivers in your
other zones and configure a remote control to work specifically in each zone, or simply to
temporarily control another zone more easily from your main remote.) To configure the
PT-7030 remote control to control a specific zone, press the In2 button and the Number
button that corresponds to the zone on the remote control at the same time.
Zone 2 = press In2 and “3”
Zone 3 = press In2 and “4”
Zone 4 = press In2 and “5”
Press In2 and 1 (or 2 if you are using Command Set 2) to return the remote to normal.