Operation instruction
5
3)
IR Receiver Window
4)
RS232 – This connector is used to deliver RS232 traffic (up to 115200 bps) over the
HDBaseT link
5)
IR-TX port - This jack can be used for connecting TX blaster cables.
6)
USB HOST (B type) -This USB port on the transmitter board connects to the USB
HOST (i.e., PC or laptop).
7)
Ethernet port–There is one standard Ethernet port
8)
HDMI Input port
9)
HDBaseT port-This is the Cat5e cable connection between the two units.
10)
DC input port- The 48V DC is the power input for the transmitter
if power adapter connects with the transmitter, the transmitter is a PSD, the receiver is a PD.
if power adapter connects with the receiver, the receiver is a PSD, the transmitter is a PD).
Note: To avoid the unit being damaged, DO NOT connect power supply for both of
transmitter and receiver.
Update instruction:
①
The user should receive a Firmware burn package, containing all software needed for
burning and updating the Firmware on the EEPROM.
②
Connect debug port use RS232 cable from RS232 port of unit to PC.
③
Power the unit.
④
Extract the zipped file from the burn package to a directory (e.g. C:\dir_name).
⑤
Browse to the directory (e.g. C:\dir_name\) and double click the batch file Update Source.
bat(for Transmitter) or Update Sink. Bat (for receiver).
⑥
A short description of the link created between the PC and the board appears on the screen,
followed by the burn progress percentage report.
⑦
A second stage of verifying the content of the EEPROM follows, also with a progress
percentage report
