Seite 29 von 39
MAINTENANCE AND CLEANING
CLEANING THE HOUSING
Switch the device off prior to cleaning, wait a few minutes and then always the plug to
disconnect the device from mains.
Clean the device using a slightly damp cloth, follow up with a dry cloth.
For safety reasons never use water to clean the device. This could be dangerous.
Never use petrol, alcohol or solvents to clean the device.
Don’t spray insecticides or similar agents onto the air conditioning unit.
CLEANING THE AIR FILTER
To assure the air conditioning unit’s proper function you should clean the air filters every
week of operation.
The air filters are located in the air inlet guard.
1.
Remove the exhaust hose.
2.
Take out the airfilter out of the air conditioner by pulling it out
sideways.
3.
Use a vacuum cleaner to remove the dust accumulated in the air
filter.
4.
If the air filter is very dirty, immerse it in warm water with a little
neutral detergent and rinse under running water (max 40 ° C).
5.
Allow the air filter to dry well after washing, and then reinstall it in
the air intake grille.
NOTE: Never use the device without the filters.
EMTYING THE WATER TANK
The device has a water pump and an automatic water evaporation system. The vaporized air
is blown out through the exhaust hose.
If the water tank is still full or the water pump fails, the air conditioner will have a water level
safety switch. When the water level reaches a certain level, the water level indicator lights up
(warning light
W.F
on the control panel) and you must drain the water tank.
To empty the condensed water tank, proceed as follows:
1. Pull the plug out of the outlet.
2. Place a catchment container underneath the
condensation outlet on the back of the device,
carefully remove the sealing cap and plug from the
outlet and drain the water into the catchment
container. Towards the end, slightly tilt the air
conditioning unit (no more than 30°) grabbing it at the handle
with one hand and at the upper edge of the air outlet with the other.
3. Once the tank is fully emptied carefully place the plug back in the water outlet and
screw the sealing cap back on.
4. Plug the device back in and start it up.
