- 3 -
The Personal Evaporative can operate with or without water. However, it will only cool the air if there
is water in the tank. If there is no water in the tank, this device will operate as a fan only, circulating
room temperature air. In addition to the fan and cooling functions, this device can also be used as a
night light, humidifier and aromatherapy diffuser.
Tip:
For maximum cooling, fill the tank with ice cold water. You can also add ice cubes if you like.
FILLING THE WATER TANK
METHOD 1
1. Hold the two top sides of the water tank and lift it upwards with your hands.
2. Open the lid and fill the tank from a faucet.
3. Replace the lid and replace the tank by sliding it back into place, following the built-in grooves.
METHOD 2
1. While the tank is still attached to the device, open the lid of the water tank.
2. Using a bottle or cup, fill the water tank.
3. Replace the lid of the water tank.
GETTING STARTED
1. After the tank has been filled, place the device on a flat, level surface. Plug the
device into an AC outlet. At this time, the screen display will be in
OFF/STANDBY
mode. Keep the device in
OFF/STANDBY
mode for 15 minutes. This will allow the
Cooling Pad to become saturated with water. Do not fill the tank without the Cooling
Pad in place.
Tip:
after the Cooling Pad is saturated, refill the tank to increase the run time by approximately 2
hours.
1
2
3
1
2
3
