Sharpe 6880, Инструкция - Каталог запасных частей

Страница: 6 / 16

Instructions/Parts
6 Maintenance
7. Reconnect drain tube to bulkhead fitting by push-
ing tube into fitting until it locks in position.
8. Reinstall side and top panels.
9. Repressurize dryer and resume operation.
Automatic Condensate Drain
Check daily to make sure automatic drain is discharging.
Replace drain mechanism yearly.
1. Shut off compressed air supply to the dryer and
depressurize.
2. Remove top panel.
3. Remove two screws holding side panel then
remove side panel by sliding upward.
4. Disconnect drain tube from bulkhead fitting in cab-
inet base. To remove, press the plastic collar in,
toward the fitting, while pulling the tube out of the
fitting.
5. Remove bowl - push bowl up, turn 1/8th turn to
your left, and pull bowl straight down.
6. Remove drain tube fitting from bottom of bowl.
7. Remove old drain mechanism by turning knurled
fitting to the right (clockwise) and remove.
8. Install new drain mechanism. If necessary, use a
wire or pencil to guide the new mechanism into
place.
9. Reassemble drain tube fitting to bowl.
10. After making sure that large o-ring in filter head is
in place, reassemble bowl to head.
11. Reconnect drain tube to bulkhead fitting by push-
ing tube into fitting until it locks in position.
12. Reinstall top and side panels.
13. Repressurize dryer and resume operation.
Element o-ring
Bowl o-ring
Tube
Separator
Element
Wave Spring
Drain
Mechanism
Hose Barb