Sharp TMV Series, Руководство по обслуживанию и запасным частям

Страница: 54 / 105

50
8. Cautions
(1) Machine Operations:
a. Check and ensure if the machine bottom
and ground base are properly contacted
before the anchor bolts are locked up.
b. The machine must be installed upon a
solid base.
c. Check and see if the motor voltage and
power source voltage are conformed.
d. Cutters shall be far away from the
workpieces when the motor is started or
stopped.
e. Switched off the power source before
gear change.
(2) Machine operator:
a. The machine is to be started or operated
by an authorized operator only.
b. Immediate stop and repair are needed in
case of troubles in operations.
c. In installation, the machine shall be
connected to earth.
d. In stop motion, the feed lever shall be
placed in neutral position.
e. The machine should be stopped during
the inspection on the workpieces.
f. In clamping, check and ensure if the
workpieces are firmly vised.
g. The spindle must be kept clean and
lubricated all the time.
h. Do not place any tools on the work table to
maintain its surface preciseness and
smoothness_
i. Prior to cutting, wait until the spindle is
running steadily after the motor is started.
j. Use a brush to clean off the iron fragments.