Sharp SW-120NC, Инструкция по эксплуатации

Страница: 43 / 111

4 ‐ 9
No Item Function Description
2
Hydraulic stop
Press this button to turn off the hydraulic motor
immediately.
When the blade is running, the hydraulic stop button
is temporarily disabled. You need to press the saw blade stop
or the saw bow up button to stop the blade first.
3
Blade start When the work piece is clamped properly, press this button
to start cutting.
A solid yellow blade icon indicates the blade has been
started.
4
Blade stop
Press this button to stop the blade.
5
Work light ON/OFF Press this button to turn on the work light.
The light bulb showing a solid yellow icon indicates the
worklight has been turned on.
6
AUTO / Manual mode Use this button to switch between automatic and manual
mode.

AUTO mode
( )
: used to automatically perform
continuous cutting jobs. When switched to this mode,
the machine will automatically operate according to
the preset parameters.

Manual mode
( )
: used to perform individual cutting
job. When switched to the Manual mode, you can
execute each individual function.
Trim Cut ‐ When the machine is switched from the
Manual mode to the AUTO mode, the first cut (trim cut) will
not be counted into finished cuts and the machine will
continue to operate according to the preset parameter. This
function allows the machine to finish the trim cut and
directly proceed into automatic cutting till the last cutting
job.
If you switch to manual mode while cutting is already
in action under AUTO mode, the machine will stop after the
individual cut is finished. Switching to manual mode at any
time other than cutting, the machine will proceed with the
next cut until it is finished.
7
Material retract 2mm
ON/OFF
When this function is turned on, the machine will retract the
material for 2mm after completing each cut before the blade
rises from its lowest position.
A solid yellow icon indicates the Material retract 2mm mode