5
INSTALLATION INSTRUCTIONS
1. Remove all packing materials from the oven cavity,
(do not remove the waveguide cover)
, and the feature
sticker from the outside of the door, if there is one. Check the unit for any damage, such as a misaligned door,
damaged door seals around the door or dents inside the oven cavity or on the door. If there is any damage,
please do not operate the oven until it has been checked by a SERVICE CENTRE APPROVED BY SHARP
and repaired, if necessary.
2.
a cupboard. It should not be installed in any area where heat and steam are generated, for example, next
to a conventional oven unit. The oven should be installed so as not to block ventilation openings.
When the oven is mounted on a kitchen benchtop, allow a space of at least 15cm on the top, 10cm on both
sides and 5cm at the rear of the oven for adequate air circulation. When installing on a shelf, the minimum
dimension of the shelf should be 719mm(W) x 456mm(D) x 467mm(H).
Do not build-in the appliance under the benchtop or any other appliances.
If the oven is to be positioned near a conventional oven, ensure that adequate space is allowed, and a suitable
heat shield is incorporated between the two to prevent damage to the oven .
WARNING: The electrical outlet must be readily accessible so that the unit can be unplugged easily in
an emergency.
The A.C. voltage must be single phase 230 – 240V, 50Hz.
3. This oven is designed to be used on a benchtop, on a shelf or built-in. The appliance must not be placed in
4. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or
5. This appliance must be earthed.
If a generator is used, do not operate the oven with non-sinusoidal outputs.
personal injury for failure to observe the correct electrical connecting procedure.
6. Operate the oven from a general purpose domestic outlet.
OVEN DIAGRAM
1. Door open button
2. Oven lamp
3. Door hinges
4. Door safety latches
5. See through door
6. Door seals and sealing surfaces
7. Waveguide cover (Do not remove)
8. Control panel (See page 6)
9. LED Display
10. Ventilation openings
11. Power supply cord
0
A
C
12. Oven Cavity
13. Outer cabinet
1
2
3
4
5
6
74
9
B
8
Accessories provided
1 ) Operation manual and Cook book
14. Flatbed
D
Содержание SM327FHS
Страница 2: ......